Entering placement position on GSM's

Subscribe to Thread

Just out of curiosity - is it possible to enter placement po... - Feb 11, 2007 by Deni

I have two gsm1's and I don't believe the current software ... - Feb 12, 2007 by

Enhanced board set-up, set conveyor width, load board, (your... - Feb 12, 2007 by

Deni

#47530

Entering placement position on GSM's | 11 February, 2007

Just out of curiosity - is it possible to enter placement positions in interactive mode (using camera image) on the GSM1 series?

- Deni

reply »

dwelch

#47556

Entering placement position on GSM's | 12 February, 2007

I have two gsm1's and I don't believe the current software can do this. Assuming you are not importing cad data, that would be the only way.

reply »

SWAG

#47557

Entering placement position on GSM's | 12 February, 2007

Enhanced board set-up, set conveyor width, load board, (your fiducials must be accurate!), use two fiducials to set reference point, click on placement(s), move crosshair to centerpoint, use two point teach to teach one point in the center or use corners for larger parts for centerline two point teach. Save product after you have done all placements you want. Do not use enhanced board set-up while product is open! - you might not be able to properly save the placement changes made in enhanced board. Hope this is what you are looking for...

reply »