IPC Standard for mechanical Hardware

Subscribe to Thread

Hello, Does any one know of an IPC standard for mechanica... - Apr 23, 2007 by

IPC-A-610D, 6.2.2 Swaged Hardware � Flared Flange ... - Apr 24, 2007 by davef

I don't know of any standards that apply to hardware at the ... - Apr 25, 2007 by Steve Thomas

Thanks for your response ... - Apr 25, 2007 by

Sundaram kumaravelu

#49233

IPC Standard for mechanical Hardware | 23 April, 2007

Hello,

Does any one know of an IPC standard for mechanical hardware. For eg we had connectors from our supplier which had 4 or more radial splits in screw mounting flange and the plating finish was not uniform on many of them. I am trying to get infomation on standards against which we could inspect hardwares. I appreciate any help in this regard.

Thanks, Sundaram

This message was posted via the Electronics Forum @

reply »

davef

#49265

IPC Standard for mechanical Hardware | 24 April, 2007

IPC-A-610D, 6.2.2 Swaged Hardware � Flared Flange

reply »

Steve Thomas

#49277

IPC Standard for mechanical Hardware | 25 April, 2007

I don't know of any standards that apply to hardware at the component level. I would think, though, that unless the spec. sheet for the component specifies cracks there shouldn't be any.

reply »

Sundaram Kumaravelu

#49278

IPC Standard for mechanical Hardware | 25 April, 2007

Thanks for your response

This message was posted via the Electronics Forum @

reply »