Feeder maintenance program

Subscribe to Thread

Hi All, I am implementing a proper feeder maintenance progr... - Nov 13, 2009 by g cronin

Normaly we clean using tooth brush with anti grease agent. ... - Nov 13, 2009 by Jagadeesh Rajagopalan

Hi! I think you need some professional help to develop yo... - Nov 17, 2009 by heba66

g cronin

#60441

Feeder maintenance program | 13 November, 2009

Hi All, I am implementing a proper feeder maintenance program for my HSP chipshooter feeders. I have the calibration jig.

I am developing a procedure with the following general steps: 1. Cleaning 2. Visual Inspection / Repair 3. Calibration / Testing

What do you do for overall cleaning? I am tempted to go as far as run each feeder head through a non-corrosive ultrasonic cleaning cycle. Then lubricate general areas with dry-film lubricant, and pivot points with grease.

If anyone has insight on how they perform maintenance I would appreciate it.

reply »

Jagadeesh Rajagopalan

#60442

Feeder maintenance program | 13 November, 2009

Normaly we clean using tooth brush with anti grease agent. Most of the time we found the eccentric pins got worn out during HSP feeder maintenance

reply »

heba66

#60460

Feeder maintenance program | 17 November, 2009

Hi! I think you need some professional help to develop your Electronics Engineering. If you need it, just visit Freelancer.com . You will find there thousands of great Mechanical Engineers who are really very helpful. You will get some extra facilities if you use this unique ' TURBOCIRCUITS' coupon word . Have a very nice time bye

reply »