GSM without side conveyors

Subscribe to Thread

Is it possible to run GSM without input/output conveyors? I ... - Dec 17, 2009 by voytek

You'll need to generate two signals - board in and board out... - Dec 19, 2009 by Deni

Get two connectors to fit the SMEMA 1 connectors on either e... - Dec 24, 2009 by NRS

voytek

#60695

GSM without side conveyors | 17 December, 2009

Is it possible to run GSM without input/output conveyors? I would have to bypass SMEMA connection I think. All help appreciated.

reply »

Deni

#60706

GSM without side conveyors | 19 December, 2009

You'll need to generate two signals - board in and board out. We have GSM that operates that way. I can send you the schematic (it's very simple) if you like...

- Deni

reply »

NRS

#60733

GSM without side conveyors | 24 December, 2009

Get two connectors to fit the SMEMA 1 connectors on either end of the machine. Need only two wires on each connector going to momentary contact sw. Input is pins 1 & 2 to switch and output side is pins 3 & 4 to switch. If this doesn't work then change the connectors to the opposite sides. Let me know if this resolves your problem. (ex UIC FE, set this up several times)

reply »