SMEMA manual interface control box schematic

Subscribe to Thread

I've seen a few used machinery companies using manual smema ... - Nov 07, 2015 by Tom

When we had a line that ended at an older reflow oven withou... - Dec 03, 2015 by ProcEng1

Thanks. Our older oven does have a basic PC interface but no... - Dec 03, 2015 by Tom

Tom

#74845

SMEMA manual interface control box schematic | 7 November, 2015

I've seen a few used machinery companies using manual smema interface boxes with a few buttons on them to simulate upline and downline equipment but I haven't found anyone selling them or info on them. Does anyone know where they can be bought or if there is a diagram available for their construction? I'm sure its pretty simple just asking before I roll my own. Thanks

reply »

ProcEng1

#75009

SMEMA manual interface control box schematic | 3 December, 2015

When we had a line that ended at an older reflow oven without SMEMA controls, I ran a momentary switch to the two pins in the connector. I push the button and the conveyor pushed the board onto the edge-hold of the oven. As a joke I labelled it "LAUNCH".

reply »

Tom

#75011

SMEMA manual interface control box schematic | 3 December, 2015

Thanks. Our older oven does have a basic PC interface but no SMEMA. Maybe I can write a short program for the oven's PC to pace the boards into the oven. I could interact with the conveyor's SMEMA interface via low-cost Arduino or something similar.

reply »