Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


FUJI CP3 WILL NOT ENGAGE

Views: 6234

#76030

FUJI CP3 WILL NOT ENGAGE | 19 July, 2016

Hello,

I am having trouble getting our old CP3 to start up. When the machine starts to run, or when we try to center the nozzles, the CAM moves to 300 degrees and stops. The station 5 rotor just turns and turns with out ever centering the nozzles. At first I assumed that there was some grease or gunk on the sensor, but I cleaned it up. I verified that the sensor is working by going into the I/O. You can see it turn on and off when the rotor is turned by hand and the zero setting dog reaches the sensor. Does anyone know what might cause this? Thanks for any help.

reply »

#76082

FUJI CP3 WILL NOT ENGAGE | 29 July, 2016

BUMP! Still having this issue. Can anyone help?

reply »

#76084

FUJI CP3 WILL NOT ENGAGE | 30 July, 2016

Loose grub screw on a sensor or rotation motor shaft ?

sarason

reply »

#76117

FUJI CP3 WILL NOT ENGAGE | 5 August, 2016

When the clutch engages the nozzle correctly does it clear the engagement sensor at the end of the brake arm? I don't remember the actual name of this sensor but it clears when the drive gear properly engages the nozzle. This ensures a zero setting on the nozzle. All of this also happens at station 12 at the same time so your problem may actually be there. Could be a component caught between the nozzle and the nozzle holder. Could be a bad sensor.

reply »

#76210

FUJI CP3 WILL NOT ENGAGE | 24 August, 2016

Did you get your problem solved? I don't remember exactly what I did for that problem but it may have involved changing a servo or driver card. I do have a copy of the calibration/repair manual if you want it. I also have some Nozzles NC-1410 (1.0 mm). Please contact me if your interested.

reply »

#76211

FUJI CP3 WILL NOT ENGAGE | 24 August, 2016

I just sent you a direct message. Thanks!

reply »

 Reflow System

Reflow Oven