Mydata TP9-UFP problem - Can't reach toolbank

Subscribe to Thread

Hi, We're having issues with our mydata tp9 pick'n place.... - Oct 22, 2018 by Filip Blad

To narrow down the cause. Have you test it on all your tool... - Oct 22, 2018 by Thomas

Yes, for all tools... The tool head stops just above the too... - Oct 23, 2018 by Filip Blad

It is probably one of the Z lock solenoids not working prope... - Oct 23, 2018 by tech1

I've checked the locks in the service program and the soleno... - Oct 24, 2018 by Filip Blad

Here is a video clip of the issue: https://photos.app.goo.gl... - Oct 24, 2018 by Filip Blad

when the machine initiates the last move it does is in the Z... - Oct 24, 2018 by tech1

You mean that the problem could be that the solenoid retract... - Oct 24, 2018 by Filip Blad

The solenoids seem to work properly and there are no problem... - Oct 24, 2018 by Filip Blad

Correct, if the Z comes into contact on it's downward stroke... - Oct 24, 2018 by tech1

It could be the indicators inside the Z head, have you tried... - Oct 24, 2018 by tech1

Picture of error in the link: https://photos.app.goo.gl/ptHc... - Oct 24, 2018 by Filip Blad

That error points to a hardware issue. When it fails does it... - Oct 24, 2018 by tech1

Filip Blad

#81276

Mydata TP9-UFP problem - Can't reach tool bank | 22 October, 2018

Hi,

We're having issues with our mydata tp9 pick'n place. It doesn't go all the way down on the tool, so it can't pick it up or install it. The fault code I get when trying to install tools is F-TLMN-18: Can't reach tool bank. Any ideas?

I've compared the parameter settings with the values shown in the "show transducers" menu for each corresponding position and they all seem to be correct, so its not that the Z-axis has "slipped" or something like that, also the machine works fine except for the "pick up tool" bit so it clearly knows where it's at. The Z-axis can reach the hight of the tool bank in other situations so there is nothing mechanical hindering it either..

Any help appreciated!

//Filip Blad, Electronic Design Lab Sweden AB

reply »

Thomas

#81278

Mydata TP9-UFP problem - Can't reach tool bank | 22 October, 2018

To narrow down the cause. Have you test it on all your tools? If only particular tool(s) having issue, then it might be tool that's having the problem.

reply »

Filip Blad

#81279

Mydata TP9-UFP problem - Can't reach tool bank | 23 October, 2018

Yes, for all tools... The tool head stops just above the tool

reply »

tech1

#81281

Mydata TP9-UFP problem - Can't reach tool bank | 23 October, 2018

It is probably one of the Z lock solenoids not working properly. These are located along the Z axis and as part of the initiation of the machine, the Z measure the travel. Check the upper and lower Z locks

reply »

Filip Blad

#81285