SMTech MV100

Subscribe to Thread

I Have a SMTech/Quad MV100 Printer and it powers up and syst... - May 07, 2019 by Paul Anderson

I have also reset and checked all the inputs are working and... - May 08, 2019 by Paul Anderson

push the 2 left buttons on the membrane panel after releasin... - May 08, 2019 by bobpan

Hi Bob, I already tried this :( Do you know the home sequenc... - May 08, 2019 by Paul Anderson

pretty sure it does squeegie blades first....then if you hav... - May 08, 2019 by bobpan

Thanks - This is exactly what it was. Separately I was isola... - May 20, 2019 by Paul Anderson

Good deal. I've had this issue many times and the magnetic ... - Jun 12, 2019 by ProcEng1

Paul Anderson

#82499

SMTech/Quad MV100 Printer | 7 May, 2019

I Have a SMTech/Quad MV100 Printer and it powers up and system on activates but does not go through home sequence - any ideas? All axis will move in the diagnostic mode

reply »

Paul Anderson

#82507

SMTech MV100 | 8 May, 2019

I have also reset and checked all the inputs are working and all seem OK.

Would be grateful if some one could confirm the home sequence, so I can at least start looking there first

Thanks in advance

reply »

bobpan

#82510

SMTech MV100 | 8 May, 2019

push the 2 left buttons on the membrane panel after releasing the e-stop....this should get you into diagnostics....you then need to reset the system parameters. It may home then.

good luck, Bob

reply »

Paul Anderson

#82511

SMTech MV100 | 8 May, 2019

Hi Bob, I already tried this :( Do you know the home sequence, as Im thinking it may be waiting for the first item to complete?

Paul

reply »

bobpan

#82515

SMTech MV100 | 8 May, 2019

pretty sure it does squeegie blades first....then if you have a table...it drops and starts to move out.....and then the head moves. Most times i have seen this....if nothing is moving....one of the cover switches are not made...use a magnet on each one to disable it. Also there is a jumper on the side of some of the machines that has to be plugged in. After this...its usually reset system parameters or reseat the firmware chips on the boards.

reply »

Paul Anderson

#82589

SMTech MV100 | 20 May, 2019

Thanks - This is exactly what it was. Separately I was isolating each of the safety circuits on the main board and that confirmed it was the top lid magnetic switch was faulty. It was the only one not shown as an input in the diagnostic page :(

reply »

ProcEng1

#82788

SMTech MV100 | 12 June, 2019

Good deal. I've had this issue many times and the magnetic switches almost always fixed it.

reply »