Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.

SMTnet
»
Electronics Forum
»
Issue with MYDATA MY19 "Transducers do not agree"

Issue with MYDATA MY19 "Transducers do not agree"

Subscribe to Thread

I am running a MYDATA MY19 machine.the problem is that the f... - Feb 12, 2020 by Alberto Alv

Do you have a photo of the actual error? ... - Feb 12, 2020 by SMTA-Alex SMTA

Thanks for responding, this is the photo of the error that a... - Feb 12, 2020 by Alberto Alv

Looks like an X-belt problem. is it tensioned correctly, not... - Feb 12, 2020 by SMTA-Alex SMTA

I was consulting the manual of the machine and to measure th... - Feb 12, 2020 by Alberto Alv

Not really, just eyeball. Does it look too loose or feel too... - Feb 12, 2020 by SMTA-Alex SMTA

I checked it and there is no problem with the lubrication th... - Feb 13, 2020 by Alberto Alv

Alberto Alv

#84430

Issue with MYDATA MY19 "Transducers do not agree" | 12 February, 2020

I am running a MYDATA MY19 machine.the problem is that the first 2 hours after turning on the machine it does not work throwing the following error: "transducers do not agree".

After approximately 1 or 2 hours the machine starts working normally.

The x belt was changed 6 months ago...

Thanks.

reply »

SMTA-Alex

#84432

Issue with MYDATA MY19 "Transducers do not agree" | 12 February, 2020

Do you have a photo of the actual error?

This message was posted via the Electronics Forum @ SMTA SMTA

reply »

Alberto Alv

#84433

Issue with MYDATA MY19 &quot;Transducers do not agree&quot; | 12 February, 2020

Thanks for responding, this is the photo of the error that appears on the screen

Attachments:

IMG-20200205-WA0000.jpg

reply »

SMTA-Alex

#84434

Issue with MYDATA MY19 &quot;Transducers do not agree&quot; | 12 February, 2020

Looks like an X-belt problem. is it tensioned correctly, not too loose or too tight? Or the X motor is acting up.

This message was posted via the Electronics Forum @ SMTA SMTA

reply »

Alberto Alv

#84435

Issue with MYDATA MY19 &amp;quot;Transducers do not agree&amp;quot; | 12 February, 2020

I was consulting the manual of the machine and to measure the tension of the x belt I need a frequency counter and two prisms but I don't have these tools, is there any other way to measure the tension?

reply »

SMTA-Alex

#84436

Issue with MYDATA MY19 &amp;quot;Transducers do not agree&amp;quot; | 12 February, 2020

Not really, just eyeball. Does it look too loose or feel too tight. Is it lubricated properly, is there enough grease on the sprockets? Also, check the ribbon cables. They might be damaged.

This message was posted via the Electronics Forum @ SMTA SMTA

reply »

Alberto Alv

#84448

Issue with MYDATA MY19 &amp;amp;quot;Transducers do not agree&amp;amp;quot; | 13 February, 2020

I checked it and there is no problem with the lubrication the cables are in good condition. The band feels a little loose I will try to make the adjustment to see if that is the problem.

reply »