Paste Stencil Mesh tension tool calibration

Subscribe to Thread

Hi all, I have a GRUNIG G-CHECK tension measurement tool, I ... - Dec 09, 2021 by Saber BOURAS

People that measure, say 4 symmetrical points() and one in t... - Dec 09, 2021 by Evtimov

Thanks, I wish all SMT quality people have the same thinking... - Dec 09, 2021 by Saber BOURAS

Totally agree with Evtimov. Let the SPI be the judge, as lon... - Dec 09, 2021 by DWL

SMT stencil standard: measure the four corners and the middl... - Dec 10, 2021 by Fly

Thanks for reply, in fact, my question is how to calibrate t... - Dec 10, 2021 by Saber BOURAS

For tool accuracy, you use calibration labs. ... - Dec 20, 2021 by Evtimov

Saber BOURAS

#87402

Paste Stencil Mesh tension tool calibration | 9 December, 2021

Hi all, I have a GRUNIG G-CHECK tension measurement tool, I need to prepare a calibration report internally.

https://graphcom.gr/product.php?lang=en&id=128

Measuring range between 7 and 50 N/cm

Thanks for sharing any useful calibration instruction or suppliers coordinates in Europe region.

reply »

Evtimov

#87404

Paste Stencil Mesh tension tool calibration | 9 December, 2021

People that measure, say 4 symmetrical points() and one in the center to get the full picture. I personally see it as a NO value added activity. If stencil changes performance - replace it.

reply »

Saber BOURAS

#87406

Paste Stencil Mesh tension tool calibration | 9 December, 2021

Thanks, I wish all SMT quality people have the same thinking.

reply »

DWL

#87408

Paste Stencil Mesh tension tool calibration | 9 December, 2021

Totally agree with Evtimov. Let the SPI be the judge, as long as your getting good prints, your stencil is fine.

I had a colleague cut the mesh on one side of a stencil and it still printed fine. This was proof to management that measuring tension was a waste of time.

reply »

Fly

#87411

Paste Stencil Mesh tension tool calibration | 10 December, 2021

SMT stencil standard: measure the four corners and the middle, target value is 26N/CM or more

reply »

Saber BOURAS

#87412

Paste Stencil Mesh tension tool calibration | 10 December, 2021

Thanks for reply, in fact, my question is how to calibrate the tool itself, it has some load spring and a gauge moving according to the tension of the mesh. I was wondering if I can make 2 different tension sets to have different comparing values, the aim is to check if the tool is still giving right reading or there are some errors.

reply »

Evtimov

#87427

Paste Stencil Mesh tension tool calibration | 20 December, 2021

For tool accuracy, you use calibration labs.

reply »