mydata disable a bad Hydra setup to continue running

Subscribe to Thread

hey all, I had a comically bad failure yesterday while worki... - Dec 21, 2021 by VT

You should able to log into the TPsys to disable the hydra h... - Dec 21, 2021 by Thomas

yeap I was able to figure it out and avoid my head being on ... - Dec 21, 2021 by VT

#87429

mydata disable a bad Hydra setup to continue running | 21 December, 2021

hey all, I had a comically bad failure yesterday while working with my pick and place, a part got dropped at exactly the wrong moment and flung a bracket up into the tool path, severely damaging the hydra controlboard that is next to the x camera. The hydra setup is toast but the midas setup seems to have survived ok. However since the hydra setup fails initilization, i can't use the machine at all. is there a way to disable the entire hydra setup so i can continue running with only the midas tool head?

thanks!

reply »

Thomas

#87432

mydata disable a bad Hydra setup to continue running | 21 December, 2021

You should able to log into the TPsys to disable the hydra head. BTW, last time I work on the Mydata machine was about 15years ago.

reply »

#87433

mydata disable a bad Hydra setup to continue running | 21 December, 2021

yeap I was able to figure it out and avoid my head being on a stick anywhere. if you log out of tpsys and into hw config you can turn off the hydra head there, then unplug the hardware and the machine will run. if you just disable it inside tpsys that is not enough and it will still fail to initialize.

reply »