Part Desc from Fujicam

Subscribe to Thread

Can anyone tell me how I can get Fujicam to add the componen... - Oct 16, 2001 by Reg

hello, You can edit the all the reports using crystal repor... - Oct 17, 2001 by

Reg

#17914

Part Desc from Fujicam | 16 October, 2001

Can anyone tell me how I can get Fujicam to add the component value/desc onto the set up sheet automatically instead of the defalt "variable" under the Status column. Thanks

reply »

lenny

#17946

Part Desc from Fujicam | 17 October, 2001

hello, You can edit the all the reports using crystal report software,so in your case you will be adding the field "description" to your feeder report,then while you are creating your your programe using the edit part command you can add your value/description on the general tab where it says description.

This message was posted via the Electronics Forum @