optimun height between lead and pad?

Subscribe to Thread

For conventional QFP device, what is the optimun height betw... - Dec 04, 2001 by

Defining the thickness of solder between the lead and the pa... - Dec 04, 2001 by davef

Andy

#18328

optimun height between lead and pad? | 4 December, 2001

For conventional QFP device, what is the optimun height between lead and pad? 50 microns or 100 microns? What is the factor affecting this height?

This message was posted via the Electronics Forum @

reply »

davef

#18330

optimun height between lead and pad? | 4 December, 2001

Defining the thickness of solder between the lead and the pad, J-001 states "Properly wetted fillet shall be evident." J-001 is available from http://www.ipc.org.

Factors that affect this are: * Amount and composition of solder * Amount and composition of flux * Lead shape, solderability protection, and solderability * Pad flatness, solderability protection, and solderability * Component weight * Reflow profile

reply »