Component testing

Subscribe to Thread

If I need to test whether our products can withstand the sol... - May 21, 2003 by

The alternative is by looking at all your components data sp... - May 22, 2003 by

Michael Ling

#24547

Component testing | 21 May, 2003

If I need to test whether our products can withstand the solder reflow process, is there any tests that I can perform other than putting the products through the actual relfow process.

This message was posted via the Electronics Forum @

reply »

AlCapone

#24559

Component testing | 22 May, 2003

The alternative is by looking at all your components data specs (heat-range), especially pay more attentions to heat-sensitive comps, and fine-pitch comps, odd-form comps, draw a diagram on a separate sheet of paper shown that temperature VS those catagories comps at the same chart, draw 2 limit line making sure those comps don't exceed the thermal shock point, and lower than a cold-solder joint point. Good luck.

reply »