difference between Q type and K type feeders

Subscribe to Thread

Does anyone know the difference between Panasert "Q" type an... - Oct 23, 2003 by CC to myself

Claude- I'll send you the answer you need in an e-mail. ... - Oct 24, 2003 by Fastek

Main difference is the reel holder position and for sure the... - Oct 25, 2003 by

CC to myself

#26148

difference between Q type and K type feeders | 23 October, 2003

Does anyone know the difference between Panasert "Q" type and "K" type feeders? If you have pictures that would be even better.

reply »

Fastek

#26168

difference between Q type and K type feeders | 24 October, 2003

Claude-

I'll send you the answer you need in an e-mail.

Rick

reply »

Gabriele

#26172

difference between Q type and K type feeders | 25 October, 2003

Main difference is the reel holder position and for sure the clamping pin location. Tape feeding system is different. Any way they cannot be compatible among them. Q type feeders must be used for MV Q-Type placer and K-type feeders must be used for MV K-type placers. My suggestion ( after many years of K-type feeder experience) if you have to buy an MV, Q-type feeders performs better then K-type and are more reliable. The feeding and reel holder system have a better mechanical design and better protection (against vibrations) for reels (mainly if above 24 mm width) when feeder carrier moves fast along Z assy .

Gabe

This message was posted via the Electronics Forum @