Magnetized HSP Nozzles

Subscribe to Thread

We were and still are having problems with magnetized nozzle... - Jan 19, 2004 by

We have four 4796 machines, and I have not yet seen this pro... - Jan 20, 2004 by

We have not checked the storage plate yet. I did send an ema... - Jan 21, 2004 by

Make sure chips (some Resistor contain nickel,or A-42 (Fe-Ni... - Jan 23, 2004 by

Any luck with the Nozzles? ... - Jan 26, 2004 by Ordie

J Smithj

#26929

Magnetized HSP Nozzles | 19 January, 2004

We were and still are having problems with magnetized nozzles on the HSP 4796. The problem was found when numerous parts were thrown after being placed on pad. It appeared to be picking parts up off the board after placement. Nozzles were pulled out and checked. These nozzles could pick up a small metal washer. After all nozzles were de- magnetized the skewing, missing parts, etc went away (on all parts). The problem is we are once again seeing the magnetized nozzle. Has anyone seen this and if so what is causing it? What is the long term fix if any?

This message was posted via the Electronics Forum @

reply »

Primus

#26933

Magnetized HSP Nozzles | 20 January, 2004

We have four 4796 machines, and I have not yet seen this problem. By chance did You check to see if the Nozzle Storage Plate is magnetized? Just a thought. Hope this helps.

reply »

J Smithj

#26944

Magnetized HSP Nozzles | 21 January, 2004

We have not checked the storage plate yet. I did send an email out to a couple of our other plants and discovered they too are seeing problems. The storage plate has come up in disscussions here. Since you mention it as well I think we should take a look. Thanks.

This message was posted via the Electronics Forum @

reply »

Gabriele

#26969

Magnetized HSP Nozzles | 23 January, 2004

Make sure chips (some Resistor contain nickel,or A-42 (Fe-Ni)leads made like SOT-23, etc )some time they also are magnetized and get attracted by nozlles tips. rgds

This message was posted via the Electronics Forum @