Sal: Now you�re talkin�, buddy!!!
Darrell is correct. All things being equal, thermal relieved vias (and through holes) should be the hottest spot on the board at reflow temperatures. Vias are gonna take on solder like drippin�s take to biscuits. And that�ll reduce the reliability of your product, and that�s in addition to the problems created by your poor solder connections.
So, the via wets with solder better than the component leads. My take on the source of the problem is one of the following: * Amount of solder paste (Well, not really, but Sal want�s to talk about this one) ;-) * Solder paste activity * Component solderability, relative to the activity of the flux of the paste you are using. * Less than optimal profile * Design of the board.
There that�s it!!! Covered all the bases. (Followed by the sound of wiping hands, patting each other on the back, and light patter of polite applause from the bank holiday crowd.)
OK ... OK, let�s go through each one. AMOUNT OF SOLDER PASTE: You probably have enough solder paste on the board, before reflow, assuming you paste is close to 50% metal, by volume and the foil is at least 6 thou. The aperture reduction of 10% from the pad size of your 30 pitch resistor networks is not necessary. On the other hand, a reduction of this amount is not uncommon and unlikely to be the cause of the insufficient solder paste and open circuit problem, you discuss. Even if there was too little paste, the component lead should still wet and complete the connection. Sal, put down from that aperture increasurometer and step away!!!! ;-) SOLDER PASTE ACTIVITY: Ahma guessin� that the solder paste is a little wimpy (prob�ly soma thet North Carolina stuff), but probably OK, because you�re suggesting that only the leads on the resistor networks are soldering poorly. Sal, you�re not holding back on us are you?? ;-) COMPONENT SOLDERABILITY: Kinda goes hip and elbow with the previous item, but if ah had to point stubby my finger at anything as being the bad boy in this, component solderability would be the one. WACKED PROFILE: If you run a long preheat and a steep ramp, you could be burnin� off your (whimpy) flux everywhere (especially your slightly corroded resnet leads) �cept the vias. Have you profiled this board to be sure your oven temperatures are good (match-up well with supplier recommendations)? DESIGN OF THE BOARD: It would be nice to have a 20 thou solder mask dam between the pad and the via, anna, may be even covering the via. It also would be nice if these vias were removed, may be 20-30 thou, from the pads.
My2� Dave F
reply »