Stencil design for Right Angle LED

Subscribe to Thread

Hi Guys.. Does anybody had experienced with designing the... - Jun 10, 2005 by Ktron

Hard to tell, but it looks as if this LED has no side termin... - Jun 10, 2005 by URL

Thank D.B. Cooper, actually this LED has 3 sides termination... - Jun 10, 2005 by Ktron

Ktron

#34873

Stencil design for Right Angle LED | 10 June, 2005

Hi Guys..

Does anybody had experienced with designing the stencil for Right Angle LED without any dewetting problem on the LED termination? Currently our stencil opening is 1:1 and we still got so high reject due to this problem.

Pls Advise, thanks

Link: http://www.fairchildsemi.com/products/opto/packaging/lamps/rightangle.html

This message was posted via the Electronics Forum @

reply »

URL

#34884

Stencil design for Right Angle LED | 10 June, 2005

Hard to tell, but it looks as if this LED has no side termination, so it may only look like dewetting. If everything around this part is reflowing, I'd bet that's all this is.

reply »

Ktron

#34893

Stencil design for Right Angle LED | 10 June, 2005

Thank D.B. Cooper, actually this LED has 3 sides termination but no termination at underneath of LED. So this LED tends to float rather than performing solder joint during reflow process.

This message was posted via the Electronics Forum @

reply »