Unisoft ProntoTEST-FIXTURE - ATE (Automatic Test Equipment) Software

Unisoft ProntoTEST-FIXTURE - ATE (Automatic Test Equipment) Software Description:

ProntoTEST-FIXTURE used by electronics manufacturers will accurately setup your Automatic Test Equipment (ATE), Flying Probe and design your "bed of nails" test fixturing.

In minutes Unisoft ProntoTEST-FIXTURE software translates CAD and Bill of Materials (BOM) files into real reference designators, netlists, X/Y component pin geometries, values, tolerances, part numbers, etc. This data is then used by Test Engineers to program their ATE (Agilent/Hewlett Packard "board & board x/y", Teradyne "ipl", Genrad ".ckt"), MDA, and flying probe test equipment and design the "Bed of Nails" test fixtures.   Receive reports used for quotations and cost estimates such as nets that cannot be accessed with a test probe, total test probes needed by size, etc. 

ProntoTEST-FIXTURE is reasonably priced and available for rental or purchase.

ProntoTEST-FIXTURE supports most popular In-circuit ATE and MDA.  Also supports Flying Probe testers such as Takaya .CA9, Teradyne Javelin, Scorpion / Innovate / Acculogic, Spea, Polar Instruments, Seica, Aeroflex, Hioki, etc. ProntoTEST-FIXTURE also creates test documentation sheets, etc.  Additionally ProntoTEST-FIXTURE provides extremely fast PC Board first article inspection and general inspection. Instantly receive a report containing device and package type counts with quotation and cost estimations. 

Also as a customer you are allowed to distribute the Unisoft Free PC Board CAD Viewer & Gerber Viewer Software to your production floor, vendors, customers, etc. to aid assembly, 1st article inspection, general inspection, repair/rework, technician debug, for better communications, etc (No need to purchase additional licenses). 

NETLIST window and blinking of all pins on the selected net

Easier drill down to component pins, trace runs and schematic.  Display NETLISTS quickly using the "NET INFORMATION" window that displays the NET NAME of the selected component and pin and all the other pins on the net. The trace run of the selected net is highlighted and all pins on the net blink. If the schematic view is displayed then the net chosen is shown. The user can then select any one of the other pins on the net in the NET INFORMATION box. The result is the NET INFORMATION window will update to the new selected pin and the selected trace highlighted will update also. If the schematic view is displayed then that view will refresh too.

Test Documentation Process Sheets

The Unisoft software allows you to quickly create matching test documentation process sheets for each step in the test process.  Part numbers can be automatically assigned to the test steps you wish (for example: Step 1 "Connector - Place Test Probes here for trace opens testing!" , Step 2 " Switch - Make sure all switches are in OPEN position prior to In-Circuit ATE testing!", etc.).  The part numbers are then automatically uniquely colored.  If needed, overlay annotation notes can be added to each step.  Next for each step matching test assembly drawings and lists are created.  These drawings can either be printed or save to a file (PDF Adobe, etc.) or displayed on the screen.

To For an online demonstration call (203) 913-0782 .