Programming Cable
Programming cables are the hardware connection for configuration & communication with all respective devices. Programming cables connect to either USB or PC Parallel ports and use fly-ware connectors to the target board.
Programming cable is available through Quick Time Engineering Inc.
Contact Blocks
A contact block is an electrical circuit connector that is used to turn on (make) or turn off (break) an electrical circuit. Contact blocks are commonly found connected to switches, relays and circuit breakers, once these devices are active the contact block allows current to flow and complete a circuit.
Contact blocks are usually designed as an accessory to fit a specific device, therefore matching the correct contact block and device are essential. The contact blocks are available with a wide range of contact configurations that allow the main device to change a circuit in many different ways. Typical contact configurations available are:
- 1NO (One normally open contact)
- 1NC (One normally closed contact)
- 1NO/1NC (One normally open and one normally closed)
- 2NO (Two normally open contact)
- 2NC (Two normally closed contact)
- 2NO/2NC (Two normally open and two normally closed)
Contact block is available through Quick Time Engineering Inc.
Quick Time Engineering Inc is an international company with offices and distribution networks in the USA, Hong Kong, Europe and Malaysia.
In its 20 years of operation since 1998, Quick Time Engineering Inc had emerged from a local engineering company with a single staff that provided solutions in factory automation to become nowadays a company that serves the Oil & Gas industries, EPC contractors, System Integrators and other industrial automation and process control companies worldwide. Customers from over 50 countries worldwide trust us with their need for process control instruments and industrial automation products.
For more information about Quick Time Engineering Inc, visit www.quicktimeonline.com or email enquiry@quicktimeonline.com