Fuji CP6-5 Servo Z overflow?

Subscribe to Thread

Hi, Our CP6-5 has a Z overflow error when trying to zero se... - Jun 19, 2006 by rtmitchell

Does it reach the home sensor ? Is it activated ? ... - Jun 19, 2006 by Choppy

Are you familar with using the mecca mode on Fuji machines? ... - Jun 21, 2006 by Daxman

problem solved. Some PCB table support pins were jammed d... - Jun 21, 2006 by rtmitchell

rtmitchell

#42267

Fuji CP6-5 Servo Z overflow? | 19 June, 2006

Hi, Our CP6-5 has a Z overflow error when trying to zero set.

The table moves in X and Y and almost zeros prior to the Z overflow.

Servo Amp?

Rob

reply »

Choppy

#42272

Fuji CP6-5 Servo Z overflow? | 19 June, 2006

Does it reach the home sensor ? Is it activated ?

reply »

Daxman

#42325

Fuji CP6-5 Servo Z overflow? | 21 June, 2006

Are you familar with using the mecca mode on Fuji machines? There is a procedure I can take you through that will check the servo amp and allow you to adjust it. Is your machine useable at all? can you get it to pass zero set? If you can, view your servo counts in the servo menu and let me know if the numbers for the Z axis are fluctuating. email me if you need assistance with mecca mode..

reply »

rtmitchell

#42335

Fuji CP6-5 Servo Z overflow? | 21 June, 2006

problem solved.

Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow.

Rob

reply »