PC Board Marking

Subscribe to Thread

What process / equipment have you found to best mark Revisio... - Jul 05, 2007 by pete

Hi Pete, Paint pens. Use different colors for different ... - Jul 05, 2007 by Real Chunks

We talked about laser marking here previously. Maybe searchi... - Jul 09, 2007 by davef

A number of years ago in a previous life, we discussed laser... - Jul 09, 2007 by robgd3

If you have a adhesive application machine such as the Creat... - Jul 19, 2007 by Chris1963

Hi Pete, we use and have been using Brady Lasertab markers, ... - Jul 19, 2007 by Jackg

pete

#50931

PC Board Marking | 5 July, 2007

What process / equipment have you found to best mark Revision levels / date codes and such onto small areas on PC Boards?

I need a repeatable, economic solution that will endure processing temps and saponifier in the cleaners.

Have used RoHS compliant epoxy ink, but have issues with finding SMALL rubber stamps.

Thanks in advance for any assistance you can provide.

reply »

Real Chunks

#50932

PC Board Marking | 5 July, 2007

Hi Pete,

Paint pens. Use different colors for different revisions.

reply »

davef

#50965

PC Board Marking | 9 July, 2007

We talked about laser marking here previously. Maybe searching for something in the fine SMTnet Archives will provide a new direction to you board marking dilemma

reply »

robgd3

#50967

PC Board Marking | 9 July, 2007

A number of years ago in a previous life, we discussed laser marking 2-d matrix codes. We had a number of boards for customers that just were too populated to get any sort of a label onto. 2-D laser units were avaialable to work in line with our automated equipment, as well.

Unfortunately, they turned out to not be cost effective for us at the time. We went with the good old fashion paint pens...and small s/n labels (heat resistant, of course) for boards that were too small...coupled with CofC's to track revision etc. A bit of a process hog when you up-rev a lot of boards, and need to keep track of it...but, still more effective for us than the marking machine.

cheers ..rob

reply »

Chris1963

#51104

PC Board Marking | 19 July, 2007

If you have a adhesive application machine such as the Creative Automation machines we use on our SMT lines you could do as our company does.

We pick a corner or an empty area on the board and apply a series of dots specifying the version you are building.

We also use one other method of board marking that is foolproof, and that is if say you build 5 different versions of the same board. Add 5 sets of fake pads to the art work, and when your boardhouse builds your PCBs have them labeled Rev A, B, C, D and E.

Then in the chipshooters program ADD a placement of a component to the appropriate pad for that rev being built. That way when you run the correct program it AUTOMATICALLY labels it for you without human involvment which can lead to mistakes.

Chris

reply »

Jackg

#51126

PC Board Marking | 19 July, 2007

Hi Pete, we use and have been using Brady Lasertab markers, they hold up through oven and wash, we use a standard laser printer (I believe we use a special toner though) and a software package called labels unlimited (can find on ebay or amazon) which is a very cheap software package and will also print barcodes. Has worked very well for us.

reply »