Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 7052
hi everyone I'm new at forum. Could someone explain me wh... - Oct 24, 2007 by mpolak
It means "difference in temperature". It's important so you... - Oct 24, 2007 by Hussman
To expound on what Hussman says, Wikipedia defines Delta (a ... - Oct 24, 2007 by Dirk Nuendyke
Actually, it applies to conditions from cold to hot AND hot ... - Oct 24, 2007 by Hussman
Actually I didn't see anything saying this person was an eng... - Oct 24, 2007 by Steve Thomas
I was asking about delta t in profiling, because I have jus... - Oct 24, 2007 by mpolak
Good points on both subjects. Not all who talk engineer spe... - Oct 24, 2007 by Hussman
Ah, see Steve, I was right. It depends Marcin. If you use ... - Oct 24, 2007 by Hussman
You may very well be right Hussman, but I'm not certain that... - Oct 24, 2007 by Steve Thomas
Ramp rate is measured in degrees per second. Max and min te... - Oct 24, 2007 by Hussman
Forget all the bickering and semantics. EVERYONE IS RIGHT!!... - Oct 25, 2007 by Dirk Nuendyke
Thanks for all your answers. Could you guys tell me how y... - Oct 25, 2007 by mpolak
OK if you could email it to me it would be great ... - Oct 25, 2007 by mpolak
No, you're wrong! All that matters is you just wear nice sh... - Oct 26, 2007 by Hussman
Rather than go into detail here, try googling "classic reflo... - Oct 26, 2007 by Steve Thomas
Marcin SMTnet will no acommodate me to attach a file on em... - Oct 26, 2007 by Paul Richardson
Oh, no daggers Steve, those are hugs where I come from. ... - Oct 26, 2007 by Hussman
its polakmarcin ( at ) o2.pl ... - Oct 26, 2007 by mpolak