Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 10136
The buyers in our company like to change the PCB finishing b... - Dec 20, 2010 by JohanH
When you say Fine Pitch is this .5mm or is it smaller? I ... - Dec 20, 2010 by R. Kondner
0.5 and 0.4 mm pitch, we think we could get problems with th... - Dec 21, 2010 by JohanH
1st the buyer shouldn't control the process based on cost. L... - Dec 21, 2010 by rem
I know when we used them we had problems when one pad is 7... - Dec 21, 2010 by WRONGWAY
Hi Johan, As a Asian board supplier - I would not recomme... - Dec 22, 2010 by BoardHouse
HI I used both of solder leveling HASL and ENIG, HASL I ca... - Dec 22, 2010 by Piter
Hi Mike, We only are using ENIG not hard gold, we are usi... - Jan 04, 2011 by JohanH
Hello Piter, I don't know which type of HASL we will be u... - Jan 04, 2011 by JohanH
Hi Johan, Sounds like you have already gone over your pro... - Jan 06, 2011 by BoardHouse