How to ??

Subscribe to Thread

I'm looking to seperate a Universal Onserter(Model #4712B) f... - Aug 23, 2001 by Compunetics

Depending on how old your through hole equipment is it shoul... - Aug 24, 2001 by CAL

Are you saying that the sensor is mounted onto the output co... - Aug 24, 2001 by Stefan Witte

Thanks for the input we found an extra sensor that plugs int... - Aug 27, 2001 by Compunetics

Compunetics

#17329

How to ?? | 23 August, 2001

I'm looking to seperate a Universal Onserter(Model #4712B) from the Gluer (Model #4713C), but I want to be able to use exiting convayor. My problem is I'm not sure on what to do with the senser that connects to the Onserter. This senser controls the convayer.

reply »

CAL

#17346

How to ?? | 24 August, 2001

Depending on how old your through hole equipment is it should be SMEMA compatible. A copy of the SMEMA wiring diagram and protocalls can be down loaded from the IPC web site Under downloadable Doccuments SMEMA Standards. SMEMA : http://www.ipc.org/html/fsresources.htm Depending on what the sensor controls this diagram should help.

Caldon W. Driscoll ACI USA 610-362-1200 cdriscoll@aciusa.org

reply »

Stefan Witte

#17350

How to ?? | 24 August, 2001

Are you saying that the sensor is mounted onto the output conveyor of the glue machine and wired into the Onserter? If so ( weird, because the glue machine should have a SMEMA interface ), than you could mount the sensor on the input conveyor of the Onserter. However, there should be another sensor on the glue machine, which stops the conveyor, if the following machine is busy. This sensor you can't remove or you will convey the boards onto the floor.

reply »

Compunetics

#17366

How to ?? | 27 August, 2001

Thanks for the input we found an extra sensor that plugs into the glue machine and now we can run the gluer without having the onseter on now.

reply »