GE Fanuc IS220UCSAH1A STANDALONE PROCESSOR MODULE

GE Fanuc IS220UCSAH1A STANDALONE PROCESSOR MODULE Description:

#Contact#
Unik You
unik@cambia.cn
+86 18030205725

The IC697 CPU and I/O system is configured with MS-DOS or Windows based programming software. There are no DIP switches or jumpers used to configure the system. The CPU verifies the actual module and rack configuration at power-up and periodically during operation. The actual configuration must be the same as the programmed configuration. Deviations are reported to the CPU alarm processor function for configured fault response. Consult Reference 1 for a description of configuration functions.

The instructions below should be followed when removing a module from its slot in a rack.
Grasp the board firmly at the top and bottom of the board cover with your thumbs on the front of the cover and your fingers on the plastic clips on the back of the cover.
Squeeze the rack clips on the back of the cover with your fingers to disengage the clip from the rack rail and pull the board firmly to remove it from the backplane connector.
Slide the board along the card guide and remove it from the rack.